Biostar 945P-A7A Owner's Manual download pdf (Page 76)

945P-A7A BIOS Manual

UR2 Duplex Mode

Select the value required by the IR device connected to the IR port. Full-duplex mode

permits simultaneous two-direction transmission. Half-duplex mode permits

transmission in one direction only at a time.

The Choices: Half (default), Full.

Onboard Parallel Port

This item allows you to determine access onboard parallel port controller with which

I/O Address.

The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.

Parallel Port Mode

The default value is SPP.

The Choices:

SPP (default) Using Parallel port as Standard Printer Port.

EPP Using Parallel Port as Enhanced Parallel Port.

ECP+EPP Using Parallel port as ECP & EPP mode.

ECP Using Parallel port as Extended Capabilities Port.

ECP Mode Use DMA

Select a DMA Channel for the port.

The Choices: 3 (default), 1.

POWER After PWR-Fail

This setting specifies whether your system will reboot after a power fail or

interrupts occurs.

Off Leaves the computer in the power off state.

On Reboots the computer.

Former-Sts Restores the system to the status before power failure or

interrupt occurs.

The Choices: Off (default), On, Former-Sts.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 87 88

No comments

Biostar 945P-A7A Owner's Manual Page 76