Biostar K8VGA-M User Manual download pdf (Page 24)

K8VGA-M BIOS Setup

User’s Manual

5.3 SUPER IO DEVICE

Press Enter to configure the Super I/O Device.

5.3.1 Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC)

installed on the system board and you wish to use it. If install and FDC

or the system has no floppy drive, select Disabled in this field.

The Choices: Enabled (default), Disabled.

5.3.2 Onboard Serial Port

Select an address and corresponding interrupt for the first and second

serial ports.

The Choices: 3F8/IRQ4 (default), Disabled, Auto, 2F8/IRQ3,

3E8/IRQ4, 2E8/IRQ3.

5.3.3 UART Mode Select

This item allows you to determine which Infrared (IR) function of

onboard I/O chip.

The Choices: Normal (default), ASKIR, IrDA, SCR .

5.3.4 RxD, TxD Active

This item allows you to determine which Infrared (IR) function of

onboard I/O chip.

The Choices: Hi / Lo (default), Hi / Hi, Lo / Hi, Lo / Lo.

5.3.5 IR Transmission Delay

This item allows you to enable/disable IR transmission delay.

The Choices: Enabled (default), Disabled.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 36 37

No comments

Biostar K8VGA-M User Manual Page 24