Biostar M7NCD Ultra Owner's Manual download pdf (Page 10)

MM77NNCCDD UUllttrraa

CHAPTER 2: HARDWARE INSTALLATION

2.1 HOW TO SETUP JUMPER

The illustration shows how jumpers are setup. When the Jumper cap is

placed on pins, the jumper is “close”. If no jum per cap is placed on the pins,

the jumper is ”open”. The illustration shows a 3-pin jumper whose pin 1and 2

are “close” when jumper cap is placed on these 2 pins.

Jumper close Jumper open Pin1-2 close

2.2 CPU INS TA LLA T ION

1. Pull the lever sideways away from the socket and then raise the lever up to

a 90-degree angle.

2. Look for the white dot/cut edge. The white dot/cut edge should point

towards the lever pivot. The CPU will fit only in the correct orientation.

3. Hold the CPU down firmly, and then close the lever.

4. Put the CPU fan on the CPU and buckle it. Connect the CPU fan power

cable to the JCFAN1. T his completes the installation.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 57 58

No comments

Biostar M7NCD Ultra Owner's Manual Page 10