Biostar M7NCD Owner's Manual download pdf (Page 8)

How to setup Jumper

The illustration shows how jumpers are setup. When the Jumper cap is placed on pins, the

jumper is “close”. If no jumper cap is placed on the pins, the jumper is ”open”. The

illustration shows a 3-pin jumper whose pin 1and 2 are “close” when jumper cap is placed

on these 2 pins.

Jumper close Jumper open Pin1-2 close

CPU Installation

Step1: Pull the lever sideway s away from the socket and then raise the lever up to a

90-degree angle.

Step2: Look for the white dot/cut edge. The white dot/cut edge should point towards the

lev er piv ot. The CPU will f it only in the correct orientation.

Step3: Hold the CPU down f irmly, and then close the lever.

Step4: Put the CPU f an on the CPU and buckle it. Connect the CPU fan power cable to

the JCFAN1. This completes the installation.

Step1 Step2 Step3 Step4

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 84 85

No comments

Biostar M7NCD Owner's Manual Page 8