Biostar MCP6PB M2+ Owner's Manual download pdf (Page 25)

MCP6PB M2+

5.3 AWARD BIOS BEEP CODE

Beep Sound Meaning

One long beep followed by two short

beeps

Video card not found or video card

memory bad

High-low siren sound CPU overheated

System will shut down automatically

One Short beep when system boot-up No error found during POST

Long beeps every other second No DRAM detected or install

5.4 EXTRA INFORMATION

CPU Overheated

If the system shutdown automatically after power on system for

seconds, that means the CPU protection function has been activated.

When the CPU is over heated, the motherboard will shutdown

automatically to avoid a damage of the CPU, and the system may not

power on again.

In this case, please double check:

1. The CPU cooler surface is placed evenly with the CPU surface.

2. CPU fan is rotated normally.

3. CPU fan speed is fulfilling with the CPU speed.

After confirmed, please follow steps below to relief the CPU protection

function.

1. Remove the power cord from power supply for seconds.

2. Wait for seconds.

3. Plug in the power cord and boot up the system.

Or you can:

1. Clear the CMOS data.

(See “Close CMOS Header: JCMOS1” section)

2. Wait for seconds.

3. Power on the system again.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 44 45

No comments

Biostar MCP6PB M2+ Owner's Manual Page 25