Biostar TP45E XE Owner's Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 59
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
TP45E XE
23
Notices:
Not all types of Intel CPU perform above overclock setting ideally; the difference will be based on the
selected CPU model.
B. Memory Integration Test (M.I.T.)
This function is under Overclocking Navigator Engine item.
MIT allows users to test memory compatibilities, and no extra devices or
software are needed.
Step 1
The default setting under this item is Disabled; the condition parameter should
be changed to “Enable to proceed this test.
BIOS SETUP UTILITY
Main Advanced
PCIP nP Boo t
Chip set O.N. E
vxx. xx (C)Cop yright 1985-200x , American Megatrends, In c.
Select Screen
Select Item
Go to Sub Screen
General Help
Sav e and Exit
Exit
Ente r
F1
F10
ESC
Over-Clocking Navigator setting
WARNING: Setting wrong values in below sections
ma y cause syste m to malfu nction.
=========== Automate OverClock System ===========
============ Manual OverClock System ============
Over-Clocking Navigator [Normal]
Aut o OverClock System [ V6-Tech En gine]
Intel(R) SpeedStep(tm) tech [Enabled]
Ratio CMOS Setting [ x8.0]
CPU Frequency Setting [200]
Ove r Clock Retry Count [ 3]
FSB(Bsel) To NorthBridge Latch [Auto]
DRA M Frequency [Auto]
Enhanced Mode [Auto]
> D RAM Timing Configur ation
> Clock Gen Configuration
> Voltage Configuration
Memory Test [Disabled]
Exit
Options
Disabled
Enabled
BIOS SETUP UTILITY
Main Advanced
PCIP nP Boo t
Chip set O.N. E
vxx. xx (C)Cop yright 1985-200x , American Megatrends, In c.
Select Screen
Select Item
Go to Sub Screen
General Help
Sav e and Exit
Exit
Ente r
F1
F10
ESC
Over-Clocking Navigator setting
WARNING: Setting wrong values in below sections
ma y cause syste m to malfu nction.
=========== Automate OverClock System ===========
============ Manual OverClock System ============
Over-Clocking Navigator [Normal]
Aut o OverClock System [ V6-Tech En gine]
Intel(R) SpeedStep(tm) tech [Enabled]
Ratio CMOS Setting [ x8.0]
CPU Frequency Setting [200]
Ove r Clock Retry Count [ 3]
FSB(Bsel) To NorthBridge Latch [Auto]
DRA M Frequency [Auto]
Enhanced Mode [Auto]
> D RAM Timing Configur ation
> Clock Gen Configuration
> Voltage Configuration
Memory Test [Enabled]
Exit
Options
Disabled
Enabled
Step 2
Save and Exit from CMOS setup and reboot the system to activate this test.
Run this test for 5 minutes (minimum) to ensure the memory stability.
Step 3
When the process is done, change the setting back fromEnable” to Disable
to complete the test.
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 58 59

Comments to this Manuals

No comments