Biostar P4TPT Owner's Manual download pdf (Page 13)

1313

EnglishEnglish

English

(2) Hard Disk Connectors: IDE1/ IDE2

The motherboard has a 32-bit Enhanced PCI IDE Controller that provides PIO

Mode 0~4, Bus Master, and Ultra DMA 33/ 66/ 100 functionality. It has two

HDD connectors IDE1 (primary) and IDE2 (secondary).

The IDE connectors can connect a master and a slave drive, so you can connect

up to four hard disk drives. The first hard drive should always be connected to

IDE1.

(3) Peripheral Component Interconnect Slots: PCI1-5

This motherboard is equipped with 5 standard PCI slots. PCI stands for

Peripheral Component Interconnect, and it is a bus standard for expansion

cards. This PCI slot is designed as 32 bits.

(4) Accelerated Graphics Port Slot: AGP1

Your monitor will attach directly to that video card. This motherboard supports

video cards for PCI slots, but it is also equipped with an Accelerated Graphics

Port (AGP). An AGP card will take advantage of AGP technology to improve

video efficiency and performance, especially with 3D graphics.

(5) Communication Network Riser Slot: CNR1 (Optional)

The CNR specification is an open Industry Standard Architecture, and it defines

a hardware scalable riser card interface, which supports modem only.

(6) Clear CMOS Jumper: JCMOS1

This jumper helps you to clear the Real Time Clock (RTC) Ram in CMOS. You

can erase the CMOS RTC Ram data to clear the CMOS memory of date, time,

and system setup parameters.

JCMOS1 Assignment

Pin 1-2 Close Normal Operation (default)

Pin 2-3 Close Clear CMOS Data

* Clear CMOS Procedures:

1. Remove AC power line.

2. Set the jumper to "Pin 2-3 Close".

3. Wait for five seconds.

4. Set the jumper to "Pin 1-2 Close".

5. Power on the AC.

6. Reset your desired password or clear the CMOS data.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 56 57

No comments

Biostar P4TPT Owner's Manual Page 13